Subject
- Posted on
October 9, 2010, 5:57 pm
Yes, an On-Topic Post in comp.robotics.misc! :-)
AHRC (Atlanta Hobby Robot Club) will host its yearly Robot Rally on
Saturday October 23, 2010, at the Pinckneyville Community Center in
Gwinnet County, int the North Metro Atlanta area. General admission
(free) starts at 10AM when you can look at robots, ask questions of
robot makers, etc., and competition starts at 11AM.
One-page PDF flyer here:
http://www.botlanta.org/uploads/pdf/Robot_Rally_2010_with_pull_tabs.pdf
Admission is free, you can bring robots to show off for free, but to
compete in any of the contests you must register your robot in advance
and pay the registration fee ($10 first robot-event, $5 for each
additional robot-event) at the Rally. More details here:
http://www.botlanta.org/registration
As always, it's sure to be a fun event for kids of all ages.
Oh, and did I say admission is FREE?
AHRC (Atlanta Hobby Robot Club) will host its yearly Robot Rally on
Saturday October 23, 2010, at the Pinckneyville Community Center in
Gwinnet County, int the North Metro Atlanta area. General admission
(free) starts at 10AM when you can look at robots, ask questions of
robot makers, etc., and competition starts at 11AM.
One-page PDF flyer here:
http://www.botlanta.org/uploads/pdf/Robot_Rally_2010_with_pull_tabs.pdf
Admission is free, you can bring robots to show off for free, but to
compete in any of the contests you must register your robot in advance
and pay the registration fee ($10 first robot-event, $5 for each
additional robot-event) at the Rally. More details here:
http://www.botlanta.org/registration
As always, it's sure to be a fun event for kids of all ages.
Oh, and did I say admission is FREE?
Site Timeline
- » Coolest Robot Videos
- — Next thread in » General Robotics Forum
-

- » 6 Overseas PhD Scholarships in 2011
- — Previous thread in » General Robotics Forum
-

- » evoMUSART 2013: First CFP (with correct dates)
- — Newest thread in » General Robotics Forum
-

- » Bending 1/8 inch thick 7075-T6 aluminum
- — The site's Newest Thread. Posted in » General Metalworking
-

- » Rysunek techniczny-pytania
- — The site's Last Updated Thread. Posted in » Engineering Science (Polish)
-




