CMU CAM 3

Translate This Thread From English to

Joe McKibben posted on
October 14, 2007, 9:09 pm

rate this thread

EXCELLENT
VERY GOOD
GOOD
FINE
BAD

Report it

Hey,

Has anyone seen this new CMU Cam? Has any one used it? What did you
think of it?

Joe McKibben

Site Timeline

» Solid State Relays
— Next thread in » General Robotics Forum

» What PWM are needed for each LCD Brightness Level
— Previous thread in » General Robotics Forum

» evoMUSART 2013: First CFP (with correct dates)
— Newest thread in » General Robotics Forum

» Bending 1/8 inch thick 7075-T6 aluminum
— The site's Newest Thread. Posted in » General Metalworking

» Rysunek techniczny-pytania
— The site's Last Updated Thread. Posted in » Engineering Science (Polish)