From time to time I get a very sharp pointed neutral flame rather than a rounded point. I've tried to add acytelene, but that just adds a feather.
It doesn't melt metal very well.
Anyone know what causes this? - Mike
From time to time I get a very sharp pointed neutral flame rather than a rounded point. I've tried to add acytelene, but that just adds a feather.
It doesn't melt metal very well.
Anyone know what causes this? - Mike
First clean your tip. If that does not do it you can gently file off the end square with a fine toothed file and try again. If the orifice is misshapen there is not much you can do. On larger tips you do get a rounded shape compared to small tips. Randy.
From time to time I get a very sharp pointed neutral flame rather than a rounded point. I've tried to add acytelene, but that just adds a feather.
It doesn't melt metal very well.
Anyone know what causes this? - Mike
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.