1. Home
  2. ✈ RC aircraft models
  3. YS91AC Parts

YS91AC Parts

Looking for a YS91AC junker...need the head..I've got a good one here
but lots of the cooling fins were broken off in a dumb thumbs
exercise.
Phil AMA609
Reply to
pcoopy
Loading thread data ...

Further Reading

  • Wanted YS91AC Junker

  • Need to replace cylinder (broken fins) on an otherwise good engine.Phil C.AMA609

  • Need YS91AC part.

  • Need a YS91AC for parts. Particularly a cylinder head. Will payshipping and...

  • YS91AC Part needed

  • You can still get most of the parts from YS...

  • Calling all YS91AC Experts

  • My YS91AC runs good above half trottle but below it gets mighty roughdown to an...

  • Bridgeport M Head parts needed

  • I recently acquired a Bridgeport M Head mill that is missing some...

  • Looking for miniature hex head bolts/cap screws

  • I'm looking for a source for stainless steel hex head bolts or capscrews in...

  • I need an old junker honda 21" mower

  • need an old honda 21 inch mower, prefer model HR215sxa, but othermodels with the...

  • NEED tig torch parts

  • I have an old Esab Heliweld 350 amp water cooled tig torch modelH35-C. I'm...

  • Dividing head parts wanted

  • I've got a little Clausing mdl 8647 dividing head. It only came with one...

  • Rebuilding early M head & need advice and parts

  • I own Bridgeport # 398 and have been using it for small projects. ...

  • still looking/parts

  • still looking for (4 )1/35th-1/40th . 1 1/2 '' - 2 "inch...

  • need good chainsaw chain

  • I bought two Logger truck loads of oak logs. They have been cut for a fair while...

  • Looking for parts for a Jet PBY 1024 Lathe

  • I am looking for a source for parts for my wife's lathe, yup, shebought it...

  • Hex head vs hex socket head

  • Assuming no counterbore and space is not a problem, how do youchoose between hex...

  • Need dimension help with parts for a compact bender

  • I keep making mistakes when I think that I got a good deal on a used item. The...

  • servo current drain rate

  • Hi all, I am trying to find out what the current drain rate is for Futaba S3003...
  • « previous thread

  • frankenstein's airplane

  • About a year ago I purchased a large collection of RC stuff which included a few...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.