1. Home
  2. ⚙ Mechanical Engineering
  3. testing of hydraulic cylinder

testing of hydraulic cylinder

hi people out there,
currently i got a few hydraulic cylinders which i wanted to test but i
can't seems to get any infomation on the testing spects, i am quite
new to hydraulic systems. just wondering if anyone here can give me
some direction on what i should find to fully test out the cylinders
and make sure that they are working fine.... thank you in advance =)
Reply to
Shurika
Loading thread data ...
Dear Shurika:
Brand and part numbers? Can the rod be extended by hand? Is the rod discolored or scored? With the rod stuck somewhere in mid-stroke, and "100 psi" applied to the piston end, how much leakage comes out the rod-end port? Same for the rod end, and leakage out the piston end? Leakage out the rod seal?
David A. Smith
Reply to
N:dlzc D:aol T:com (dlzc)

Site Timeline

Related

  • Effectiveness of Diameter Reduction in Hydraulic Cylinder Blind End

  • Hydraulics is not my specialty, so please excuse me if I mis-useterminology,...

  • Hydraulic Bandsaw Feed cylinder oil fill level?

  • Hey guys,can someone out there shed some light on how much oil should be put ina...

  • How to properly fix a leaking hydraulic cylinder?

  • I have a log splitter that is leaking fluid from the side of thecylinder. I...

  • Testing hydraulic cylinders

  • for a video of test of these cylinders with compressed air,...

  • hydraulic cylinder tubing

  • Does anyone know a good source for small quantities of hydraulic...

  • Testing hydraulic cylinders -- VIDEOS

  • You can see that the rod is moving relatively smoothly, except at thelast moment...

  • Hydraulic cylinder source?

  • Anyone have any suggestions for a source of hydraulic cylinders for a small...

  • Hydraulic cylinder material

  • Hi folks,Can anybody suggest me good weblinks etc for referring variousmaterials...

  • Pneumatic/hydraulic cylinder question

  • Hello Guys Can I use a pneumatic cylinder as a hydraulic cylinder, as long...

  • enerpac hydraulic cylinder

  • I'm in the market for a 30 ton cylinder to go with my enerpac airdriven...

  • rebuild Enerpac hydraulic cylinder

  • Has anybody here ever rebuilt an enerpac 10,000 PSI hydraulic cylinder? i blew...

  • Pitting on Hydraulic Cylinder

  • A 10 cm dia. hydraulic cylinder on an industrial truck has some eroded areas 1-...

  • Small Hydraulic Cylinder

  • Hi Group , Well I have gotten some good help before here so will try again . I...

  • Hydraulic cylinder/valve question

  • One of my machines has a 2" x 10" cylinder controlled by a 4 way electric valve...

  • Small Hydraulic Cylinder Diagram?

  • First and foremost - happy 2007 to everyone!Okay... Embarrassed to ask this...

  • Disassembling a Hydraulic Cylinder

  • If you have to drill or cut into it you can buy replacement parts here:...

  • hollow hydraulic cylinder - why?

  • I found a hollow Enerpac 12kpsi portapower cylinder recently. I'm...

  • Using hydraulic cylinder as pump

  • Hi guys:I have an application where I need a foot-operated, reciprocating...

  • RESULT Testing hydraulic cylinders

  • I tested one of them with compressed air, it went very ineventful, theram slowly...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.