Short, reviewed reading paths through existing discussions. Each guide puts a few complementary threads in order, with a note on why each one is worth reading.
A damaged or unfamiliar thread usually raises the same chain of questions: what size and pitch it is, what drill to use before tapping, how deep the thread needs to go, and what to do once a hole has...
7 discussions · reviewed Oct 8, 2026 by Site editor
Gluing metal, or metal to another material, starts with choosing an adhesive that suits the joint, the load and the conditions it will live in. These discussions run in that order: comparing two-part...
7 discussions · reviewed Oct 8, 2026 by Site editor
An old engine-drive welder, such as a Lincoln SA-200, a Ranger 8 or a Miller Big D4, is two machines in one: an engine and a welding generator. These seven discussions follow the job of owning one in...
7 discussions · reviewed Oct 8, 2026 by Site editor
Bending steel bar, tube or sheet at home usually means getting a clean angle or an even curve with a vise, a torch and whatever can be made into a form. These discussions start with small flat bar, mo...
8 discussions · reviewed Oct 8, 2026 by Site editor
Most grinder jobs depend on putting the right wheel, brush or disc on the right tool and mounting it properly. These discussions follow that order: picking wire brushes and flap discs, getting cut-off...
6 discussions · reviewed Oct 8, 2026 by Site editor