What is the point of this "pot turner"? You seem to imply that you're trying to control the cut current of a plasma cutter from the CNC, and per the folks who make the plasma cutters, including the hi-def ones, controlling the current during CNC cutting provides little to no benefit.
The plasma cutters don't have such a control input (at least the typical air plasma units don't), because there is no need for them.
Many units do have a control input for "arc on" and an output for "arc good" and an arc voltage tap as standard equipment, because those are the control signals required for CNC control, but arc current is not needed as a dynamic control.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required