I need some gears, 127/72 compund and some to mesh these to. and a 40 to go with the 127. I am after some cutters or maybe some gears. the gears are meant to be 32dp 14.5°. it's a cva in case anyone has some and they don't need them;-)
-- richard
Richard, Why do you need a 40 T wheel for a CVA A 40 T in the 32DP range isn't listed.
Full set of 32 DP's for BA and metric are with boss:- 43, 48 [2 off ], 50,
53, 55, 56, 59, 60, 65, 66, 70, 72, 73, 75, 80, 81, 85. Plate gear 127 [ 2 off ], 152.Full set of 16 DP's for standard ranges are with boss:-
23, 24, 25, 26, 28, 29, 48, 57, 61, 63, 67 Plate gear 30, 33, 34, 35, 36, 37, 38, 39, 40, 41, 43, 45, 46, 47, 49, 50, 51, 5, 54, 55, 56, 58, 59, 60, 62, 64, 65, 66, 68, 70, 71, 72, 73.-- Regards,
John Stevenson Nottingham, England.
I was sitting here feeling pissed at what i just spent on a oddball metric tap, i wrote the post without a look at the online cva manual - well no i haven't finished it.. got it wrong, nothing strange there.
er, thats a 'few' gears, must have caused a national gear shortage when they were supplying them with all the gears..
I think a hobber is called for.
by the way john what was the ajax manual you said you had? I am informed my ajax is an AJT3, I should give the head a mild seeing to the gear drive pulley wobbles a bit and i have to sort out the feed, it works perfectly when it's not needed;-)
-- richard
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.