Mars Exploration Rover Update - April 29, 2006

formatting link
OPPORTUNITY UPDATE: Opportunity Hits 800 Sol Mark! - sol 796-803, Apr 29, 2006:

Opportunity is healthy and making good progress towards "Victoria Crater," with just under 1,400 meters (.86 mile) to go. The team spent several days this week setting up for some robotic arm work over the weekend, provided there is a good piece of outcrop in the work volume. Opportunity will continue driving next week.

Sol-by-sol summaries:

Sol 796 (April 20, 2006): Opportunity ended a drive after 2 meters (about 7 feet). Imaging taken before and after the drive was completed.

Sol 797: The rover conducted untargeted remote science, including panoramic camera and miniature thermal emission spectrometer ground surveys and atmospheric measurements.

Sol 798: The rover completed targeted remote science, including panoramic camera images of targets "Junction City," "Chetopa," "Coffeyville" and "Salina," and miniature thermal emission spectrometer stares of "Junction City" and "Salina."

Sol 799: Opportunity had a great drive today, traveling approximately

44 meters (144 feet).

Sol 800(April 24, 2006): Happy 800! Opportunity drove 33.5 meters (110 feet) today, crossing a few small ripples and driving over an outcrop.

Sol 801: After taking a pre-drive image, Opportunity drove 28.3 meters (93 feet), down a couple of troughs and over a couple of ripples. Slip checks were used to prevent excessive driving in potentially slippery areas.

Sol 802: This sol's 13.8 meter (45 feet) drive was designed to move Opportunity closer to some outcrop the team would like to analyze with the robotic arm over the weekend.

Sol 803: The outcrop that ended up in the rover's work volume was fragmented, and not a desirable target. Rover planners designed a short

8-meter (26 feet) drive to a better target. The data from this drive was received on Earth early Friday (April 28, 2006).

As of Sol 802, Opportunity's total odometry was 7,456.56 meters (4.63 miles)

Reply to
baalke
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.