Best plasma cutter for the money?

winster · 2006-03-18T00:47:22+00:00

I recently had a burglury at my home. I lost a Miller Spectrum 625 anda Millermatic 251. The Miller Spectrum 625 was o.k. but always seemedslightly underpowered. I operate a feedmill and a couple of retailstores. Maintenance is in-house and we fab a lot of our own parts andsome products(gates, panels,round pens etc.) Occasionally I or myemployees need to cut or sever plate greater than 1/2". I have heardgood things about Hypertherm and Thermaldynamics, and I know thequality of Miller. But can anyone help me narrow my choice?

B

BigTwin 20 years ago

Hey Martin, come to think of it, that is one of the reasons I wanted a plasma too!!! I want to make a set of falling plates, with a reset string. I am not even sure if I can hit the dam things since I wear glasses for reading now.. Have not tried competition on bowling pins, etc for years!!!

Regards

Vote

B

BigTwin 20 years ago

thanks for the tips Wayne. The local dealer doesn't seem to budge on prices.

I have a Miller legend, Ltec MigMaster 250. tanks torches, and a bunch of buzz boxes. I have been playing with welders since highschool. I don't do it for a living. Not sure if I would want to. My eyes are going as it is. One part of getting older that really sucks.

Vote

B

BigTwin 20 years ago

thanks for the tips Wayne. The local dealer doesn't seem to budge on prices.

I have a Miller legend, Ltec MigMaster 250. tanks torches, and a bunch of buzz boxes. I have been playing with welders since highschool. I don't do it for a living. Not sure if I would want to. My eyes are going as it is. One part of getting older that really sucks.

Vote