Great suggestion!
Reading plans and cutting parts
Oct 07, 2004
26 Replies
on balsa, I cut slightly oversize and sand to the line. I can't keep an xacto or scroll saw goin straight! Probably a personal problem! :-)
don't go there. There might be some ladies in here. hehehe.
a LOT smaller than a BLKCH! Haaaar.
Now there is a good on topic discussion! Good job guys!
"jeboba" wrote in news:Vkx9d.5$Rp4.2@trnddc01:
Unfortunately, the 'same copier' trick works only if a) the copier resizes the same way in both directions, or b) all of the parts on the plan have the same orientation. If the copier stretches things a bit horizontally and shrinks a bit vertically, and if, say, your fuselage formers are shown in a different orientation than your fuse sides . . . lots of sanding and Zap-a-Gap . . .
hmmm, good point!
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required