Bridgeport LSI-11

8 discussions on PolyTech Forum about the Bridgeport LSI-11: what owners asked, what went wrong, and what fixed it.

What owners report

Vertical Mill - $300 Craigslist

If you look carefully at the one photo, I think the badge on themachine head says Index. It's in Reading, PA. They're selling it atabout the scrap price.

CNC Bridgeport with Heidenhein control

Someone is offering me a Bridgeport Series II Interact CNC mill. Hesays that it worked but the Heidenhein controller is no longeroperational. Whether this is true or not, as always is questionable. The price is $500. My question is, can...

I can now run EMC2 and it kind of "works"

wiring garage with Ethernet last night I moved on a bit. Workeduntil 2am. I have configured my mill PC to run EMC2 with "ppmc" configuration. I tried to do a good job, so that all configs are in my CVS sourcetree, there are shell aliases...

CNC Bridgeport with Heidenhein control

Someone is offering me a Bridgeport Series II Interact CNC mill. Hesays that it worked but the Heidenhein controller is no longeroperational. Whether this is true or not, as always is questionable. The price is $500. My question is, can...

Your worst project?

What was the most ill-conceived, unsuccessful, and worthless/expensiveDIY style project that you undertook (I would say without counting anyinjuries as they could outweigh everything else)?My biggest one is a shed that I built. Not counting...

OT-Odd (to me) computer failure

So my computer starts to act up. I had to fix some files. More filesdamaged so I shut the thing off with plans to only turn on the thingone more time to get everything off of the hard drive. I take it tothe local computer place and the guy...

All discussions