1. Home
  2. Metallurgy discussions
  3. Charpy V Notch Values for 10B38 or 1045 at 50-60 HRc

Charpy V Notch Values for 10B38 or 1045 at 50-60 HRc

I am interested in finding the impact values or other ductile brittle
information on either of these steels. We are producing a part that could be
used in the arctic than has an induction hardened wear surface.
Thanks. Ed
Reply to
Ed
Loading thread data ...

Site Timeline

Related

  • 1095, torsion and charpy

  • ...

  • Homemade Izod/Charpy impact machine

  • Yes, someone who has built an impact tester would be a great help to you. This...

  • Hardening and Tempering SAE 1045

  • I may be telling you something you already know, so excuse me in advance ifI am,...

  • Why 50/60 Hz?

  • All over the world 50 Hz or 60 Hz is used as the frequencyfor AC voltage from...

  • Hardness of Titanium on the HRc ? ? ? ?

  • It ist not very much wear resistant.AFAIK, Titanium hardness ist too low for...

  • 50 - 60 Hz system

  • hey folks...... could anyone post da advantages and disadvantages ofhaving 50...

  • Any tips for turning 1045 steel

  • Hello all,I have an old smallish English lathe that I use for hobby stuff....

  • Notch sensitivity in a threaded fastener

  • I'm doing a fatigue analysis on a threaded fastener. It's...

  • 50 / 60 Hz, was passiert?

  • haben, sondern 220/230V 60 Hz. Ich wohne in einem 60 Hz-Land. vielen Motoren...

  • Charpy Impact Test

  • Does anyone know where I can find a simple picture of a Charpy ImpactTest...

  • 60 Hz Vs 50 Hz

  • In USA supply is in 60 Hz whereas in other country it is 50 Hz why thisis so?

  • Devices to convert 240 v, 50 H to 120v 60 Hz?

  • Thank you John G, Palindr?me and Furles, for the very helpful comments.My film...

  • Pico 60 für Keller 50/7 ???

  • Hallo NG,reicht ein Pico 60 für den Keller 50/7???Der Motor soll mit 14,4V...

  • 50 Hz motor on 60 Hz

  • I just picked up my first metal lathe. It was originally sold by Warco,a British...

  • Athearn SD-50 / RPP SD-60 questions

  • First I have a few questions regarding the Athearn SD-50. In the add, it says...

  • Changing AC 50 cycles to 60 cycles

  • I used a timer clock in Germany that runs on ac 50 cycles.Now at home my ac is...

  • Rhenium Notch Sensitivity

  • I am looking for any information on the notch sensitivity of Rheniumat room and...

  • overriding dimension values in drawings

  • hi,got a couple questions for 2001:1. Can anyone tell me how to override...

  • digitale Notch Filter

  • Hallo zusammen,irgendwann hab ich mal mitbekommen, dass wenn man die Abtastrate...

  • Contactor coil: 50 Hz vs. 60 Hz

  • I may be able to obtain a very small 2-pole 240 vac contactor I need rated for...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.