Replacement motor for Warco WMT300/1 Lathe/Mill

Does anyone know where I can get a replacement motor to fit a Warco WMT300/1 Lathe/Mill.

I just bought one of these machines with a known faulty motor. On dismantling the motor, I found burned-out stator coil windings caused by part of the centrifugal switch mechanism touching the windings and eventually breaking through the insulation. I'm a bit concerned that another Warco supplied motor might suffer the same fate so I woud prefer to go for an alternative make.

Thanks GaryB

Reply to
Loading thread data ...

there was one on fleebay not so long ago don't know if it went or is still going. not much help but a start

Reply to

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.