Pro/DESKTOP newbie question: radial constraint possible?

- J
- J. Haider
  
  Contact options for registered users
posted
20 years ago

Wed, Jul 9, 2003 6:19 PM

Hello Pro/D experts,

I'm starting to learn Pro/D (Express). In Design mode, I'm stuck with this problem:

- I draw a circle with say 40 mm diameter

- I draw a smaller circle concentric inside the first one

- now I want to put a dimensional constraint _between_ the two circles, specifiying a 5 mm "wall thickness"

- this should result in an inner circle that's always 10 mm smaller in diameter than the larger one...

...how can this be achieved??

Any help and ideas highly appreciated.

Thanks,

Hans

Loading thread data ...

- J
- J. Haider
  
  Contact options for registered users
Vote on answer
posted
20 years ago

Thu, Jul 10, 2003 2:32 PM

Hello David,

thanks a lot for your input. Since the part (a pipe clamp) is a bit more complicated than I described, the first alternative works beautifully here.

Thanks again,

Hans

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.