Anyone ever figured a way to trick Mcam to do a Face roughing boring cycle where the tool cuts from Id to Od. I have a deep bore that I would rather not have the very first cut be the boring bar buried to full depth.
Man I HATE Mcam lathe, no wonder everyone hand codes.....
ca
Chain the geo from id to od, in parameters, select face on cut type
"Flexability" And I beens usin the stuff fer mor than a year!! Seriously, there is a lot of toolpath power right there, I do 99.99% of my lathe programs with no toolpath editing. The other .01% I just havent found in the toolbox I call Mastercam.
"D"
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.