Problem with Cincinnati milacron VMC Sabre 2000,Help.

I have a Cincinnati Milacron vmc Sabre 2000 with Vickers Acramatic 2100 control. The tool data is not getting loaded during start up, error message, "application time out" with "subscript out of range". With this problem I could not take tool offset. Please help. Thank You. M. Amalanathan.

Reply to
man
Loading thread data ...

It sounds like you may need to get the software reloaded. I have run Cincy mills for many years and never saw that one. That is not a numbered Error code that Cincy uses. Siemans has taken the Vickers controls over now, sorry I don't know their website URL off hand but some searching will find it. A couple of Siemans guys have frequented this newsgroup from time to time, maybe one of them will chime in.

I really think your exec software has a problem. You didn't mention any Error codes, is there nothing in the Control Maintenance Manual in reference to this problem? If it isn't there you need tech support to fix it. On that machine a flash card reload may be in order.

Reply to
Michael

Hate to say this, but it could be your hard drive starting to die. I got these sort of errors when ours gave up the ghost.

Hope you have a back up drive.

Later Jim

Reply to
jimz

Thak you for your kind reply, on looking the error message it shows "tol.exe" file got corrupted. If you can please help. Thank you, WIth regards M. Amalanathan.

Reply to
man

Thank you for your kind reply. I do not have any back up. How can I get it, please let me know.

Thank you With regards M.Amalanathan.

Reply to
man

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.