⧑ Industrial Control Group

  1. Home
  2. ⧑ Industrial Control Group
2150 Threads Posts
to

PID tuning

Hi all, I am working on positional control of an BLDC motor ,i am using TIDSP as an controller and I want to follow the...
1 comments posted 22yrs
posted by sudheervemana
1 comments posted 22yrs posted by sudheervemana

National Instrument CAN bus card version 2 and 1?

Could some one please tell me what is the difference between the new Series2 national instrument CAN bus pci card versu...
0 comments posted 22yrs
posted by spmok2
0 comments posted 22yrs posted by spmok2

Statistics + WAP?

Where may one read more about the statistical software that may be implanted onto existinf software systems and get the...
1 comments posted 22yrs
posted by yu_gas
1 comments posted 22yrs posted by yu_gas

E-stop on a conveyor: hardwired or PLC?

What is the standard practice for wiring a conveyor e-stop? My intuition says that you would hard wire in a relay, but...
9 comments posted 22yrs
posted by kcolvin
9 comments posted 22yrs posted by kcolvin

termnal block question

I have been trying to figure out what kind of rail Weidmuller SAK 4 terminal blocks use. There's a pic here (left) alon...
3 comments posted 22yrs
posted by doc
3 comments posted 22yrs posted by doc

Beginner Practical Control System

Hello, Does anybody have any recommendations on building a simple system that can demonstrate some of the basic princip...
3 comments posted 22yrs
posted by lpkeys
3 comments posted 22yrs posted by lpkeys

Analog mA to digital HART conversion

I was tasked to find out about (off-the-shelf) ways to convert a conventional analog mA message into digital HART infor...
2 comments posted 22yrs
posted by markusk_address_messed_up_inte
2 comments posted 22yrs posted by markusk_address_messed_up_inte

Single phase motor controller.

I know this is a very rudimentary question, but here goes anyway. I've got some small machine tools that I would like t...
17 comments posted 22yrs
posted by lasernerd
17 comments posted 22yrs posted by lasernerd

selecting Data Acquisition system

I am looking for information on selecting Data Acquisition system. Currently I have: http://www.eleusa.com/pdf/3.pdf I...
6 comments posted 22yrs
posted by old
6 comments posted 22yrs posted by old

I build rubber brains !

Yes, they are great, because they will just bounce of if the fall out of the nose while sneezing. A normal brain will la...
0 comments posted 22yrs
posted by celt_sites
0 comments posted 22yrs posted by celt_sites

Is ISA a rip-off?

Casually surfed over to ISA with a thought of joining - until I saw that the standards will cost you USD9.50 each and o...
42 comments posted 22yrs
posted by PR
42 comments posted 22yrs posted by PR

how to determine encoder resolution

Hello, We wish to control an axis using servo motors. How do you determine how much resolution you need on the encoder....
7 comments posted 22yrs
posted by denault
7 comments posted 22yrs posted by denault

about suspension vehicle control system analysis

can anyone help me with the informations about suspension vehicle modelling for my final assignment thank u so much
2 comments posted 22yrs
posted by wahyuagung_2002
2 comments posted 22yrs posted by wahyuagung_2002