Hi, Can anyone recommend a piece of equipment to continuously monitor 10-20 connector pin pairs for loss of continuity? A dropout as short as 1us has to be detected. This will be a long term test through hot, cold and vibration conditions. Will some type of data acquisition equipment work? Thanks in advance, Mike
Reliability Testing - Connectors
Oct 28, 2004
2 Replies
can the pins be all wired in series for the test?
check out the logic analyzers at
formatting link
The 10-20 pairs already takes into account 5 or 6 in series. It's an 80 pin connector and we would like to know the general area of failure if any. That's why I was looking for 10-20 channels.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required