Once it is running, this desktop machine covers a wide range of work. The maker ran cuts and engravings on basswood, acrylic, slate, leatherette and anodized aluminum, and the finished pieces include engraved metal business cards, acrylic badges, slate coasters, a cut wooden clock face and a rotary-engraved insulated tumbler. Under the lid sit two sources: a 10-watt 455 nm diode with a blue spot of .08mm and a 2-watt 1064 nm infrared unit. The whole thing is packaged as a deep getting-started walkthrough.
Getting there takes a few deliberate steps. The machine sits beside a matching white desktop smoke purifier, and the two are linked by a USB-C synchronization cable running from the purifier's F1 port to a port on the engraver's rear, while a white flexible duct is pressed onto the exhaust port and routed into the purifier's intake. A green front cover opens to remove the rubber lens cap, the software then detects the machine and prompts a firmware update, and the purifier offers a 3-position fan speed switch.
What stands out is how much supporting material came out of this. There is a downloadable alignment template for the included fixturing bracket, a full fixturing kit for the machine, and a cutting clearance and fit test designed for slot and tab style panels and boxes. Shared material settings should get newcomers cutting sooner, and material thickness can be set to 2 mm in the software. Focusing is covered both ways: an autofocus sequence checks vertical clearance before the motorized head climbs the Z-axis column, and a manual method uses the side-mounted dial to line up the red and blue targeting dots.
The one caveat the maker flagged is that cut edges on this machine can come out slightly beveled. With a .08mm spot, I would also be curious how small text can go on wood before detail breaks down; that seems like the natural next experiment.
Project by Embrace Making. Watch it on their YouTube channel: