5 discussions on PolyTech Forum about the Bridgeport QC30: what owners asked, what went wrong, and what fixed it.
Having just bought the Beaver turret mill, I am now on the lookout for some30Int tooling for it. I have loads of 40Int for the A&S mills (1ES and 2ES) butsod's law says I have to get a vertical with something different!Talking with John S...
We have been looking at various accessories and 'goodies' for the new Beavermill, and have had lots of 'nudges' from the more knowledgeable on the newsgroup(received with thanks!)We did get a lot of stuff when Bob West closed his workshop...
I have an idea there was some discussion touching on this a while ago(Andrew?), but can't find it by looking back.I've just successfully modified a BT30/ER32 collet chuck to be closeenough to QC30 to function without a problem in my...
I've got a fair selection (about twenty) QC-30 holders with my 'new' BP Series-1, but I'm interested in sourcing more in the future.So far, I find a fair bit of CAT-40 stuff, but virtually no 30-taper holders.Any good ideas?LLoyd
This Bridgeport Interact 2 mill comes with "QC 30" toolholders. Isthat the same as NMTB 30, as far as mounting goes?thanksi