6 discussions on PolyTech Forum about the Miller LMSW-52: what owners asked, what went wrong, and what fixed it.
Well , new to me . Found a Lincoln Weldpak 175 in like-new condition , he was asking $375 I offered $275 and he accepted . It really is like new , contactor tip is clean and so is the nozzle . It also came with a 2lb roll of flux core...
Well , new to me . Found a Lincoln Weldpak 175 in like-new condition , he was asking $375 I offered $275 and he accepted . It really is like new , contactor tip is clean and so is the nozzle . It also came with a 2lb roll of flux core...
My 30" 3-in-1 combo machine can bend 22ga steel but not the 18ga that matches the 1mm thickness of the rusted car area. I just ordered a 4", 14ga vise brake from Amazon. Is there anything I should know about their use, capabilities or...
Need help with Miller spot welder. It's a LMSW-52. I bought at auctionwhile back and don't really have a steady use for it, but sometimessomething comes up and I'll try it. At first it would weld but now I can'tget any heat out of it. ...
I ordered a sort of handheld type spot welder. It's Miller and rated something like 6000A with the 6" tongs and uses 220V. I called to make sure it's ok to use at 240 (and not go into saturation) or 208 and was told no problem as the...
Got a Miller LMSW-52 at an auction awhile back. I used it a few times, butnow it won't work. Transformer hums, but no weld. Anybody haveexperience/advice on this unit?Thanks.