Got a Miller LMSW-52 at an auction awhile back. I used it a few times, but now it won't work. Transformer hums, but no weld. Anybody have experience/advice on this unit? Thanks.
spot welder
Jan 26, 2004
2 Replies
I have the same one.
You can download the manual from Miller's website
formatting link
The most common cause is bad contact tips. If they get loose and overheated you get a layer of copper oxide in the threads that prevents full contact.
There isn't much else too these things. A transformer and a switch. The switch could be bad. It costs about $25 to replace.
Might try to read the AC voltage on the bars. See if something is there. Often there is a low voltage light bulb wired to the two mains - to show function. Then like Ernie said - it is in the threads or contact tips.
Martin
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required