5 discussions on PolyTech Forum about the Miller LN-25: what owners asked, what went wrong, and what fixed it.
I do ornamental iron to occasional heavy fabrication. I've managed to get b y with my Lincoln SP170T MIG for light fab and ornamental work, and my Maxs tar 200 using TIG for heavy ornamental and stick for industrial. Now I've got a heavy...
Anybody have any comments on these voltage sensing wire feeders.I seelots of used Lincoln LN25's on the used market but I am looking at aused Miller 8VS with a 180 amp torch.I am hoping to run .035 and.045dual shield mild steel and SS...
Guys, I need some advice and help... I came across a used LN25 CV/CC wirefeeder recently, and hooked it all up today just to see if the feeder worked. Ran the heavy input lead to the back of my POWCON and plugged it into the (+) receptacle,...
I have a Hobart handler (120) and a Syncrowave 250. during my last job I didall my welding with my mig even though I should have stopped and switched tomy tig to do the heavy (1/2") pieces welding, so I was doing multiple passeswith my mig...
I'll apologize in advance for being somewhat vague about what I'm after. And probably for using more verbosity than is really necessary. A first word about my experience: 35 yrs of all kinds of welding. Lots and lots of stick and heli-arc...