1. Home
  2. Metallurgy discussions
  3. Phase rule

Phase rule

In a simple binary phase diagram, according to the phase rule,
#Phase + #Freedom = #Component + 1 (pressure is fixed).
Then, the eutectic point will have 0 degree of freedom.
Does this rule apply to a spinodal decomposition as well?
Reply to
skailup
Loading thread data ...

Site Timeline

Related

  • 3 phase to 1 phase

  • I found a Hunter DSP 9000 wheel balancer I would like to have for my home shop....

  • Three Phase/Single Phase Voltage Fluctuations

  • Some voltage rise is OK on the unloaded phases when a single phase loadis...

  • Stepping up 208V 3-phase to 240V 3-phase ?

  • I have 208V wye 3-phase in my shop. From the recommendation of this group,I...

  • Phase Converter

  • I remember one time asking about having a 3 phase line put in, itsabout 1/4 mile...

  • SILVERDRIVE phase converters

  • Does anyone know anything about these converters please.I'm doing a bit of a...

  • Single phase motor

  • Hi again.Well I'm looking at a Denford Viceroy Centre Lathe. TDS1, but it...

  • Phase converter won't spin compressor

  • I removed all the wire nuts from the compressor motor, straightened thestrands...

  • Paralleling phase converters?

  • I have read here that some folks use more than one phase converter intheir shops...

  • Iron-Titanium Phase Diagram

  • Someone has recently asked for the iron-titanium phase diagram. Now...

  • three phase transformer question

  • I have a three phase transformer, with which I want to do somethinginteresting...

  • Converting a six phase rectifier to three phase rectifier

  • Thanks for yesterday' suggestions regarding 3 phase transformers. I have a...

  • Converting Miller GoldStar 300SS to single phase???

  • I recently sold a Miller GoldStar 300SS welder. It is a very basicthree phase...

  • Boxford STS lathe conversion to single phase

  • I have just bought a 3 phase Boxford STS and would like to convert it to...

  • Phase II collet indexer

  • You can access the website as posted. You may find that on some pagesthere are...

  • Re: Phase rule

  • Only once you have reached the final equilibrium concentrations, and it doesnot...

  • Three phase wiring question

  • Well, if you know which outlets run it backwards it should be pretty simple....

  • Phase diagram of Inconel 625

  • You can ask for a binary phase diagram, Ni-Cr maybe.You can ask for a ternary...

  • 3 phase inverter schematic diagram?

  • Hi all folks,I need to build a single-to-3 phase converter for a motor rated...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.