1. Home
  2. ⏣ General Metalworking
  3. Aloris dovetail dimensions

Aloris dovetail dimensions

Looking for a site that lists the dovetail dimensions for Aloris or FIMS
toolholders. Thanks
Reply to
Chief McGee
Loading thread data ...

Further Reading

  • CA Toolholder dovetail dimensions?

  • Does anyone have a reference for the dovetail dimensions on a CA seriesAloris QC...

  • Trailer and dovetail

  • Just been thinking, if a person were to build a 12 foot trailer with adovetail,...

  • Does anybody sell pre-made dovetail stock?

  • You can get bronze plated steel dovetail components from these...

  • Dovetail slide??

  • Is it possible (I guess it is a question of geometry) to make/machinea dovetail...

  • Dovetail angles

  • I was going to make some stops for the mill table. I thought it would be simple...

  • Dimensions of an anvil?

  • Ernie, or anyone else that might care to chip in -- Where could I find the basic...

  • Candlepin Bowling Pin Dimensions

  • Would anyone have knowledge of the approximate dimensions of aCandlepin Bowling...

  • Feasibility of retrofit dovetail on 20' flatbed gooseneck trailer

  • Greetings,I recently acquired an old 20' gooseneck flatbed trailer. ...

  • Gas Cylinder Dimensions

  • We are building a number of different welding carts and are lookingfor the...

  • Dovetail problem

  • I picked up a 12 x 24 Atlas lathe to extend the capabilities of my 6 x 18 Atlas....

  • 5C Collet Dimensions?

  • Does anyone know where I can find the specs for a 5C collet? I want to makea...

  • R8 Taper Dimensions

  • I bought a cheap R8 collet for use in my neighbor's equally cheap vertical...

  • Dovetail mils

  • If you don't mind making the dovetails in sections; you can get a bigpiece...

  • Dovetail Column Mill

  • I am interested in getting a RF-45 bench type mill. Thing is, I amnot convinced...

  • Dimensions

  • Working mainly on European designs I'm used to metric dimensioning but out...

  • How would you do this?

  • Hello all I am currently prototyping a new project for a customer. One part is a...
  • « previous thread

  • How to make a cam lock device

  • Hello! Im building a sheet metal brake and am looking at ideas to hold the clamp...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.