1. Home
  2. ⚙ Model Engineering in the UK
  3. aluminum mesh

aluminum mesh

I'm looking for this sort of mesh:
formatting link

in aluminum say 6060 to 6063 or something at a thickness of about .6mm to
1mm - the holes are 1mm Dia. and about 1.5mm apart.
I need this from the UK but haven't been able to find a supplier - any
thoughts?
Thanks,
J
Reply to
James
Loading thread data ...
Tis okay - I just realised that its called perforated and not mesh over here - doh :)
Reply to
James
Try
formatting link

-- Regards,
John Stevenson Nottingham, England.
Reply to
John Stevenson

Further Reading

  • Joining aluminum to aluminum mesh

  • Hi,I'm wondering what the best way to do this is (I'm not a...

  • Joining aluminum to aluminum mesh

  • Hi,I'm wondering what the best way to do this is (I'm not a...

  • Calculating surface of wire mesh

  • Hi to all. Can someone explain me how to calculate the surface of 10x10cm -- 1mm...

  • Wire Mesh Pads (Where to Find?)

  • Anyone know where to get either wire mesh or curly wire mesh pads like...

  • drilling 6063 aluminum, burr on breakthrough

  • I could not get 1/8 x 4 flat in 6061 so they sold me 6063-t6. 3/8"hole at 2037...

  • Where can I get aluminum mesh?

  • Hi, where can I buy large peices of aluminum mesh? Would Home Depot carry these...

  • Straightening Rolled Welded Wire Mesh

  • Has anyone found a good way to straighten wire mesh solo? The grass isn't...

  • Screen Mesh

  • Could someone tell me the definition of a screen's mesh? I am working on...

  • fine mesh

  • Hi all,I'm trying to find a fine mesh for 1/32 - 1/35 scale vehicles to use...

  • Mesh projection

  • How can I obtain the polylines of the projection of a mesh to the XY plane ?Are...

  • Mesh Wire

  • Conveyor Belt, Braided Hose, Weaving, Filters, Wire Mesh, Wire...

  • Photo To Mesh

  • PhotoToMesh is a standalone application which creates 3D meshes fromphotographs...

  • Aluminum question

  • Looking for type of aluminum that is used in electronic chasis.Bendable,...

  • WIRE MESH GUARDS

  • Hi,Is there an easy way to make wire mesh guards in SW2005?. Or do you have to...

  • Epoxy casting repair?

  • (Posted separately to ) I've got a badly corroded cast iron gearbox casing to...
  • « previous thread

  • chemical etching/milling

  • I was hoping someone could point me in the right direction with regards to...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.