A helicopter powered by ground spun flywheels instead of rotor speed

Nov 14, 2026 Last reply: 3 hours ago 2 Replies
Jump to replies (2)

The starting point is a simple question: how high could an unpowered, hand-spun propeller toy fly? The maker ran a long way with that thought, building a kinetically powered helicopter that banks energy in high-speed counter-rotating flywheels rather than in a fast rotor. The flywheels get their spin from a ground launch station, and the craft then flies on that banked rotational energy.



The layout pairs two matched flywheels on a horizontal axle, with custom 5:1 bevel gears carrying that power to the vertical rotor mast. Variable-pitch composite blades mount on a machined rotor head with pushrods to a center control rod, and a servo beneath the chassis moves the pushrod to change blade pitch. Onboard go a microcontroller board, battery pack, telemetry, altitude sensors and an RC receiver. For yaw, laser-cut foam vanes with servo-driven flaps hang under the rotor disc, catching downwash. The machining is serious: waterjet-cut gear blanks, bevel gears profiled on a 5-axis mill, and the trusses, bearing blocks and pitch hub milled from solid aluminum billet.



Two details stand out. Gyroscopic precession was first shown on a handheld rig with a single flywheel on a pivot, and running the two flywheels opposite ways cancels that effect. The open-spoked aluminum flywheels also acted as air impellers, with drag estimated near 20 horsepower. Tests topped out around 1,300 RPM against a 24,000 RPM target, but once heat-shrink monokote turned the spokes into smooth discs, liftoff came within the dock guide rails.



The open question is yaw control. Pairing the flywheels in opposite directions cancels precession, yet it does nothing against the rotor's reaction torque, so the body spins without any anti-torque. In a low hover the vanes were overwhelmed and the maker forced the craft down with negative pitch, while enlarged foam surfaces still lacked authority for a sustained hover. The outdoor flight rose tens of feet while whirling wildly, veered across the yard and slammed into a UTV, damaging the chassis. A ground-up redesign is planned.



Project by Stuff Made Here. Watch it on their YouTube channel:

formatting link


Choosing variable-pitch autorotation for recovery instead of a pyrotechnic parachute seems like the smart call. A parachute around all that spinning hardware invites entanglement, while autorotation needs no extra consumables on board. The trade-off is that recovery rests entirely on blade pitch control, and that was exactly the system struggling to hold authority in hover. Even so, planning a safe return for a heavy mechanism before the first launch shows good discipline.

For the redesign I would try a small tail rotor geared off the rotor mast in place of the downwash vanes. The vanes kept losing the fight with reaction torque even after being enlarged, and a mechanical tail rotor counters that torque directly. It would add weight to a 2.7 pound craft, but yaw authority seems worth that cost given how the outdoor flight ended.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required