MH-60L DAP Black Hawk with laser-cut canopy masks

Nov 19, 2026 Last reply: 2 hours ago 3 Replies
Jump to replies (3)

The detail that grabbed me first is the masking. MM Scale Models cuts custom canopy masks from yellow tape on a desktop laser cutter, then backs them up with blue liquid masking fluid. At 1/48 the canopy frames on an ICM Black Hawk are fiddly, and machine-cut tape seems a smart route to crisp edges where a hand-cut mask would wander.



The assembly shown is proper interior work. Seats, bulkheads, instrument consoles and cabin flooring come off the sprues with flush nippers and a hobby knife, then go together with liquid plastic cement and tweezers. Everything gets primed and base-coated by airbrush, using 0.3mm and 0.2mm brushes and paints such as Mr. Finishing Surfacer 1500 Black, MRP-040 Olive Drab and MRP-077 NATO Black.



The finishing is where it stands out for me. A white Prismacolor pencil picks out the switches, dials and interior edges, which must make those consoles pop at this size. Panel definition comes from Tamiya Panel Line Accent Color in Medium Gray and Black, worked in with cotton swabs and dry brushing. That combination of pale highlights and dark accents sounds well judged for a cockpit this small.



Alongside the modelling, the narration runs through the story of the 160th regiment, the Night Stalkers, tracing the MH-60 back to the failed 1980 Eagle Claw hostage rescue in Iran and on through Urgent Fury, Earnest Will and Prime Chance. Pairing a build with that history gives it real weight.



One open question for me: the stages covered so far centre on the cabin and cockpit, so the rest of the airframe is still ahead. I would like to know whether the exterior gets the same layered weathering as the interior.



Project by MM Scale Models. Watch it on their YouTube channel:

formatting link


The laser-cut tape masks strike me as the cleverest call in the whole build. Cutting them by machine should give repeatable, consistent frame lines on curved canopy parts, which is exactly where hand-cut tape tends to slip. The trade-off is the extra kit and setup compared with just a blade and a steady hand, but for a canopy this small it looks worth it to me.

I would like to know how the two accent colours were divided up. Did the Medium Gray go on the floor and larger panels while the Black was kept for the consoles and shadow lines, or was it decided panel by panel? At 1/48 that choice must make a big difference to how the cockpit reads.

Since the sludge oil paint is already on the bench, it could be worked into the seams of the cabin flooring to deepen the shadows around the seat rails and bulkheads. That would layer nicely with the panel line accents and the white pencil highlights, and it would tie the cockpit and cabin together visually instead of each area reading separately.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required