All,
I'm using 2007 sp3.1 and have not used this option in a while... How can I invoke ,or un-gray, the projected tolerance (PTZ) option? Whatz the trick or selection to get it to work? I want to add it an existing positional toler frame but will attached approx if needed?
TIA!
I assume you mean that it is still grayed out when you click to enter the tolerance amount? This is the only time that it should not be grayed out. I am currently able to use it on my service pack 3.1 install.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.