brake press services needed in WA (east side of Lk WA)

Jun 01, 2005 1 Replies

Rate this thread:

ryanw59 21 years ago

I have a 5'x3' piece of SS that I need a 30 degree bend put in. Anyone know of a good place on the east side (Kirkland/Woodinville/Bothell) that could do this for a minimal fee? This is thin SS, formerly a commercial kitchen fryer hood.

Vote

Ernie Leimkuhler 21 years ago

Vulcan Products in Woodinville is a great fab shop.

I use them for large bends and curves in tubes, but they will do any size job.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required