Miller Snap Start - HF-251 differences??

TIA for any information on the following units:

Is the Snap Start able to output continuous HF or is it only for arc starting?

What is the diffrence between the Snap Start and Snap Start II? Are they both 115v?

Is the only difference between a HF-251D-1 and HF-251-2 that one is 115v and the other 230v?

Reply to
Loading thread data ...

If you post this over at

formatting link
can give you a prompt answer. The miller and hobart factory guys run the board and everyone from factory techs to development managers chime in.


Reply to

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.