Every year, my wife in I get into fierce arguments about why and how the crappy plastic pool sucks works or doesn't work. My latest theory is that it is working worse than before because the 1 HP electric motor attached to it is slowly degrading and isn't truly 1 HP anymore. Does this happen? Would it make sense for me to get the motor tested somewhere?
Thanks
Didn't find your answer? Ask the community — no account required.
D
DaveB
Well, it may be cheaper than getting rid of your wife
Regards
Daveb
S
SQLit
Motor is probably ok, it is the pump that is wearing down ( probably)
I have had 4 pools and 4 different kinds of cleaners. The best one (and the worst to keep running) was a in-floor system. It was a battle 2 or 3 times a season working on it. Replacing parts on the distributor etc. I had a Hayward powered by the pool pump, (no separate motor needed) on the last pool. It required maintenance 1-2 times a season. Nothing made from plastic holds up to the plaster and dirt in the water for very long.
I used nothing but brass pumps. Tired the others and they just did not cut the mustard. I had to get new impellers about every 5-6 years to keep the volume where it needed to be.
I was lucky and had a mom-pop pool shop near by. They never steered me wrong. I tried to jump the tracks and save a buck or two and they always said that I would regret the decision. Damn they were always right. If your motor and pump have some seasons on it. Pull it and take it to a shop and have it inspected for a rebuild. I did that and they sold me a new set up for about $100 bucks more than the rebuild and I did not have to wait. The new motor was less hp, less amps, and more gallons than the old one. I truly believe you get what you pay for in pool equipment.
G
grinder
It's probably the pump and not the motor. The impellers are typically plastic and will wear down quickly if there is no flow (as when the basket gets clogged).
J
John Rigler
You guys rock, all I had to do was clean the impeller, but this does go to show that my motor was the smallest possible to do the job, I estimate that in order to get up enough pressure to push the cleaner around the pool, I have to cut off 2/3 of the pressure going to the DE tank.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required
Report Content
You are reporting this content to the moderators. They will look at it
ASAP.