Layered Tree Side Table with Backlit Acrylic on a Steel Tray Base

Nov 17, 2026 Last reply: 22 hours ago 3 Replies
Jump to replies (3)

The trickiest part of this build has to be keeping five stacked wood layers and an acrylic base in register, since a tree motif only reads correctly if every cut lines up. The maker solved that by cutting alignment holes into the same sheets as the artwork and dropping in 3D-printed plastic pegs, which seems like a tidy, repeatable way to guarantee the stack sits true.



The foundation is an IKEA powder-coated steel tray table. A hole was drilled through the bottom edge with a step drill bit so a 5V 5mm COB LED strip with an inline controller could be passed through and mounted along the inner rim on 3M double-sided tape. On top of that sits a 6mm clear acrylic sheet as the diffuser, then five 3mm basswood plywood rings carrying the layered Tree of Life design, all dusted down with a cordless air duster before assembly and finished with a protective clear acrylic top plate.



Cutting was done on an xTool P3 80W CO2 machine driven by xTool Studio. Fume handling got real attention: an IF2 inline exhaust fan, custom 3D-printed 90-degree hose adapters, a 4 inch hose adapter, and an AP2 MAX filtration unit. Cabling underneath was bundled with zip ties on adhesive mounts, and a magnetic USB power bank sits flush against the steel base to run the lighting.



The one open question is whether that 6mm acrylic thickness is what lets the whole tree glow evenly, and nobody has confirmed it yet. Custom cut glass tops were also floated as a future alternative, which leaves an interesting door open for a version two.



Project by Embrace Making. Watch it on their YouTube channel:

formatting link


The magnetic power bank mounted flush to the steel tray base is the choice that stands out to me. As an opinion, it keeps the underside clean with no visible wiring, and the zip tie bundling backs that up. The trade-off is that the lighting lives on a battery, so someone using this as an everyday lamp would be recharging it regularly rather than just leaving it plugged in.

I am curious about the alignment pegs. Were the alignment holes cut in the same job as the tree motif for each sheet, and did the printed pegs get a snug press fit so the five rings could not drift while the clear top plate went on? With 3mm plywood, even a small amount of play between layers seems like it would show up in the finished design.

Since custom cut glass tops were already mentioned as a possible future direction, a slightly tinted glass top seems like the natural next step for this table. My thinking is that a tint could deepen the contrast of the lit tree against the dark surround, and glass would add a different feel to a piece meant for modern rooms. It would be worth testing a tinted sample over the existing stack before committing.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required