Frosted Laser Engraved Wedding Champagne Flutes

Nov 14, 2026 Last reply: 4 hours ago 3 Replies
Jump to replies (3)

The tricky part of this project is obvious the moment you think about it: a champagne flute is curved, narrow at the top, and reflective, so etching a clean band around it is not simple. The maker tackled it by sizing the artwork to match the base circumference, measuring with a flexible tape measure, and tucking a blue shop cloth into the cavity to tame reflections coming off the inside of the glass. That last move is the kind of fix you only learn by running into the problem yourself.



The build itself is nicely methodical. The design was laid out in Adobe Illustrator on a 1.5 by 1.7 inch artboard at 70% grayscale, then processed through Epilog Dashboard at 400 DPI, 35% speed, and 100% power. The flute sits base down on the rotary drive wheels of an Epilog machine, and the cloth stays in place for the whole pass. A center-center engraving method was used to line everything up.



What stands out to me is the attention to the geometry. The maker stretched the design roughly 10% along the rotational axis to compensate for the curve, and the finished result is a crisp frosted emblem, a wreath encircling the name, ready as a gift for a wedding couple. The presentation on a dark coaster makes the frost really pop, in my view.



The one open point is that 10% stretch figure. It reads as an approximation tied to this particular base size, so whether it transfers to flutes with different proportions seems worth testing before committing a gift piece.



Project by Maker Experiment. Watch it on their YouTube channel:

formatting link


The cloth inside the flute is the smartest call here, in my opinion. Glass bounces a laser beam around in ways that can ghost your artwork, and killing those reflections from within is a cheap fix that costs nothing but a shop cloth. The trade-off is you have to trust it stays put while the rotary spins, but for a wraparound design that seems like a very fair bet to take.

I am curious about the measuring step. With a flexible tape wrapped around the base, how did the maker decide exactly where to stop reading the circumference before transferring that number to the artboard width? Was there any overlap allowance in the wrap, or was it a single clean reading straight into Illustrator? That measurement seems like the hinge the whole layout depends on.

One improvement I would suggest: before engraving the gift piece, run the same 400 DPI, 35% speed, 100% power recipe on a spare glass at a couple of different grayscale values around that 70% mark. Comparing the frost depth side by side would show how sensitive the finish is, and it would also confirm whether the 10% stretch holds before risking the real flutes.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required