1. Home
  2. ⚗ Material Sciences
  3. ATC Ceramic

ATC Ceramic

Anybody having experience with ceramic coating for tools?
I am looking for some information about ATC Ceramic (Al2O3-TiC-Cobalt)
coating to tools.
Some other suggestion for wear resistant Ceramic coating to tools
(required to used at 700=B0C and 40 HRC) will be highly appriciated.
sincerely,
BG
Reply to
billghutes1
Loading thread data ...

Further Reading

  • ATC Ceramic

  • Anybody having experience with ceramic coating for tools?I am looking for some...

  • ITC 213 Ceramic Coating

  • Has anyone benefited from using ITC213 Ceramic coating ontheir graphite or metal...

  • Ceramic Chip Forge

  • A month or so ago I bought a very nice Flamefast ceramic chip forgefrom a very...

  • Turning Ceramic Material on a Lathe

  • I have been attempting to turn down the diameter of some small ceramicmagnets. ...

  • Flamefast DS230 Ceramic Chip Forge

  • :) But I do still have the Flamefast Ceramic Chip Hearth !!!! Andrew

  • Iroquois Ironworker - anybody have experience with them?

  • Anybody have any experience with the iroquois ironworker line ofproducts? ...

  • Using ceramic tile in place of fire brick

  • Hello all,I am new to welding and am starting with Gas to get some...

  • machining ceramic

  • Have some prototype ceramic fixturing to make. Machinable alumina bisque and...

  • transparent ceramic

  • Hello everyone!I am interested in working on processing (fabrication)of...

  • Drilling Ceramic

  • I need to drill an array of holes in a ceramic (Macor) plate.Each hole will be...

  • Ceramic Gyroscope

  • Hi,Does anybody know where to get tolkin CG-16D or CG-43D, CG-53D gyros in the...

  • Sharpen ceramic knife

  • My $5.00 ceramic knife has lost it's razor edge after about 6 months of ...

  • Ceramic kitchen knives

  • I would like to try buying a ceramic kitchen knife like this ebay...

  • ceramic shell repair?

  • Hi!My school recently got its furnace running again, and I'm doing...

  • EC-funded Research Visits: Application Deadline 31/08/2006

  • --------------------------------------------------- Next HPC-EUROPA deadline for...
  • « previous thread

  • who knows how to add Si into Mg melt?

  • I've prepared it by using the method that mentioned in some articles.Directly...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.