1. Home
  2. Metallurgy discussions
  3. Are HOMO and COW good alloys?

Are HOMO and COW good alloys?

Or are HoMo and CoW alloys crap ?
What about CaOs and ScAm ?
I hope there will be a new element called "Ap" soon, so that I can
finally make "CrAp".
Reply to
Rick Stoll
Loading thread data ...

Site Timeline

Related

  • Cow magnets ??

  • Yesterday i called the local hobby shop to ask if they carry the newsuper...

  • Welding sintered alloys?

  • --A pal of mine designs jewelry that's then manufactured using a 3-Dprinter...

  • Yes, of course, amalgams are alloys

  • Yet again Keith P. Walsh has been a source of ignorance and confusion.He...

  • Tungsten-cobalt alloys extremely carcinogenic?

  • A little distraction from our "show us Obama Bin Laden's deathcertificate"...

  • Titanium Alloys?

  • Have some 0.030" 6Al4V sheet I was trying to heat-treat and it was warping so...

  • Steel alloys FCMS BMS and MS

  • I've been reading some "how to" books on making various lathe items and...

  • Bristol Alloys

  • Anyone use certified material from Bristol Alloys inanything...

  • Bristol Alloys

  • Anyone use certified material from Bristol Alloys inanything...

  • Aluminium alloys

  • Hello all. Could anyone point me to a web page that describesthe common...

  • Some questions about Aluminum Alloys...

  • Hello.I'm attempting to write a story set in Eric Flint's 1632...

  • Electropolishing Mg-Zn and Mg-Al alloys.

  • I'm looking to electropolish magnesium alloys containing either aluminium...

  • Homemade alloys

  • They actually use two different alloys. One for the walls and one for thelids...

  • Identifying aluminum alloys

  • Hi,I imagine this is a common question, if it's addressed in a FAQ or...

  • holey cow

  • Their site is a nightmare.5.5" chassis punch cutting 0.039" sheet? Oh yeah.That...

  • Modelik Homo sapiens, skala 1:6!!!!

  • Witam wszystkich, chciałbym się wszem i wobec pochwalić, że od wczoraj od...

  • Alluminum-copper alloys

  • Most wrought Aluminum Alloys have Cu in them. That is what allows them tobe...

  • Holy Cow!!

  • on 10/16/2007 2:40 AM Stephen Tontoni said the following:Did he kill, or down, a...

  • sacred cow

  • Not sure- it's been a while. When I last saw it (about 4 years ago)...

  • Keystock as Lathe Bits ?

  • [ ... ] Well ... this was a clean cut -- if you like chisel points. Maybe that...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.