Direct Chill Casting

• Can someone direct me to some trip hammer plans?

• I used the Kinyon plans to build my hammer. However I would call them a...

• Can someone id this lathe ?

• That lathe uses oil lubrikation, no grease in there.I checked the type of oil,...

• can someone please help me identify this device.

• I shot this picture of the device on what I believe is a power line.It appears...

• Can someone comfirm this?

• Make a part with multiple configurations, say 1 to 3, make then so that they are...

• Can someone please tell me...

• what a "bort" number is? I can't seem to find an online definition...

• Can someone please tell me what this is (electrical)?

• As I said earlier there are a heck of a lot of ways to make a motor, thereare...

• Please Can Someone ID Electrical Contactors

• hello everyonegot a breakdown.....all work on latest project stopped because of...

• Can someone ID this lathe?

• I just picked up an old and somewhat rusty lathe but can't figure outwhat it...

• Can someone help this person?

• ...

• Can someone explain this wrench?

• Hi Folks,This is the tailstock wrench that came with my 1941 South...

• can someone identify this mill

• found it on craigslist, didnt buy it ($500.00 asking price), but I was...

• Can someone id this ceramic

• I have two little bricks, about 2x2x7 inches or so, or greyceramic. It is easily...

• Can someone identify this boat?

• I was looking at pics of the Dutch IPMS 2006 and spotted a ratherinteresting...

• Can someone identify this aircraft stretcher?

• A friend has a strechter that appears to have been used in an aircraft, judging...

• maxwell / voight models - can someone check this for me please...?

• Tutorial question was given.....The Creep response of a polymer corresponding to...

• Can someone identify this model kit?

• I found this beautifully built model of a Showman's Road Locomotive.Here are...

• Can someone identify this kit ...

• Should be one of these sets:http://www.peeron.com/inv/parts/6075because you see...

• Can someone identify this rotary table?

• Hi!Got an rotary table (2 axes of rotation; 200 mm diameter) today.Nice...

• Can someone explain this ? Induction problems.

• I'm trying to get a current from an induction coil. For some reasonthe...

• Can I convert my MIG (A365 mig 100) to a TIG, Is this possible please?

• Hi guys I'm wondering is it possible to convert my A365 MIG 100 electric pr...