1. Home
  2. Metallurgy discussions
  3. How to avoid Ferrit??

How to avoid Ferrit??

hello,
im casting pig iron with high amount of phosphor ( about 3 percent) and i
get 40- 50 percent Ferrit.
by 1,5 percent phosphor i dont have such problem ( 8-10 percent ferrit)
does anybody have an idea what i can change
the time from casting to unpacking is about 1 hour
Reply to
sebastian
Loading thread data ...

Site Timeline

Related

  • starting with jlink; pointer to a hello world ?

  • Hi all,I'm just tinkering with jlink, well mostly I'm fascinated by the...

  • How to rust proof cast iron

  • I'm building a 1/3 scale hit miss engine. The flywheel rims will be bare...

  • How to handle small amount of salt.

  • Hello,A question of new-bee. Recently I usually deal with weighing of a...

  • How to spring load pig cooker lid for easy opening-closing

  • I am helping a friend build a pig cooker out of a propane tank (about30" in dia....

  • Attaching phosphor to zinc

  • I have zinc particles of 0,3-1,0 mm on which I have to attach phophorparticles...

  • Iron casting

  • Hi all,I am planning to make my own furnace for Iron Casting (as well as ali,...

  • How to insert amount of parts in a note?

  • Hello,My note attached to a part shows several properties taken from...

  • Ferrit-Antenne

  • Hallo,welchen Vorteil hat der Werkstoff Ferrit als Antenne, der Ferrit-Antenne ?...

  • Btu's per Pound to melt different metals?

  • AFS Cupola Handbook says 1 pound of Coke will melt 6 pounds of Cast Iron.

  • Hello Dah Lih?

  • Shopping manual mills for a friend.Ran across a Dah Lih vertical.Looks to have...

  • Avoid welding distortion

  • I have to make a fair number of 5' x 5' aluminum frames out of 1" by...

  • How to tell high speed steel from carbon steel

  • I have a few "Ace" taps made by Hanson. (large sizes, 5/8 to 7/8NC). They do not...

  • Lost wax casting iron

  • I want to lost wax cast some small statuary in cast iron - this sameitem I have...

  • How to cure diluted PDMS with solvent

  • Hi,I am doing some work with adding on a thin layer of PDMS that is diluted with...

  • How to Weld cast iron with internal thread

  • The traveling nut on my vise broke and I need to weld it back together with...

  • How to open a Mosler safe with combination?

  • The note might be a pig Latin note of sorts - writtenin reverse to fake out the...

  • --> *Non Engine*Cast Iron Crack Repair - How To?

  • Likely, but cast iron is a weird character, and there are so manyvariations and...

  • Phosphor bronze rivets?

  • Why phosphor bronze? Phosphor bronze is a bearing material, and there are many...

  • How to increase the high T performance of polyurethane

  • Hello, the mechanical properties of polyurethane composite decreasefast with...

  • how to seal high pressure microfluid with thread?

  • Hi all, I want to connect two parts by threading. Usuallyto seal it you...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.