1. Home
  2. ⏣ General Metalworking
  3. Anyone got a hardness tester?

Anyone got a hardness tester?

I have a little test I want to do involving steel and hardness; if there's
someone who would be willing to test some small bits of steel I would be
grateful...
(email has anti-spam stuff)
Reply to
_
Loading thread data ...
See yer local heat treater. They usually have one.
Reply to
Proctologically Violated©®

Further Reading

  • How to use an old Rockwell hardness tester

  • Hi All, I've gotten a Rockwell hardness tester without instructions. It...

  • Need manual for Rockwell Hardness tester

  • Anyone got the manual for a Rockwell Hardness tester made by Wilson, Model...

  • Hardness Tester

  • I have a need for a hardness tester, and was thinking of making the Dave Lammas...

  • Hardness tester

  • Greetings,A friend and I are building a heat treating oven for his knife making...

  • ames hardness tester

  • Greetings,I'm looking for a diamond penetrator for my Ames hardness...

  • Hardness Tester Repair

  • Does anyone know of a place in Northern California that can repair/calibrate a...

  • Hardness tester wanted

  • Does anybody have a hardness tester laying around? Gunner has five or six...

  • Steel boats anyone?

  • Hello,I was just wondering if anyone here was into steel boat building?Gil.

  • Wilson 3R hardness tester accessories?

  • Where can I get accessories for the Wilson 3R hardness tester? Operatorsmanual?...

  • Anyone have a Rapidor?

  • I have just invested in an old Rapidor power hacksaw (one that takes14" blades),...

  • Sheet steel hardness

  • I have some drawn parts to make and have one drawing die done, the part...

  • annealed steel hardness

  • I have two samples of steel, one that is annealed, and one that is not.Both...

  • "Growler" armature tester

  • I have recently aquired an old Allen Electric Type E30 armature tester. It's...

  • Brinell Hardness Test in a Foundry

  • Hi,I was asked a question in my materials testing class about why afoundry...

  • Annealing

  • If I wanted to soften a bit of steel, could I do so in a kitchen oven? I know it...
  • « previous thread

  • Determining/Defining metal toughness

  • Awl-- Recently saw sumpn on cable regarding nylon, kevlar, spider's silk, etc....
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.