1. Home
  2. ⏣ General Metalworking
  3. FS: Precision Preloaded double-bearing Shaft-Mounts

FS: Precision Preloaded double-bearing Shaft-Mounts

Very high quality shaft mounts.
formatting link

Reply to
Richard
Loading thread data ...

Further Reading

  • precision shaft engineering

  • Hi,Im realy an electronics enigineer but my project has a shaft wich is 1 meter...

  • Shaft Wear

  • In our robot drivetrain we have a set of 20 DP (3/8" face width) gearswith a...

  • precision shaft, final challange - balancing.

  • Hi,Ive got my 1.2M long 12mm shaft running quite well,the standard deviation of...

  • Assembling a preloaded milling spindle

  • I have been restoring a Westbury (original form) milling machine andhave just...

  • Basic bearing/shaft fit question

  • Since the load direction is constant relative to the non-rotating inner race,...

  • Shaft mounted drill chuck?

  • I bought a used Fisher Scientific overhead lab mixer. The mixer motoris a...

  • Cutting bearing races

  • This bearing was really in tight, with some rust helping things. Thinkof it as...

  • bearing seal

  • I got to the bottom of my CNC mill trouble... I need an extremely odd size...

  • Flail mower shaft

  • I was the lucky bidder on a five foot Bush Hog flail mower a couple weeksago....

  • Tig brazing for shaft repair?

  • Hi folks.I have a shaft I am trying to repair. The shaft is the upper shaft...

  • precision shaft continued - looking for supplier in uk

  • Colin, It is not pretty to watch your discomfort.So if you can't use a...

  • sintered bronze lathe bearing

  • Trevor,I understand the concept of what you saying... make a cut from the OD of...

  • Is keeping load on an idle shaft bearing bad?

  • One of my anchor customers asked me this and I really couldn't answer. It is...

  • center-drilling large shaft?

  • I want to center drill a large shaft. The shaft is about 24" long andis from an...

  • Nut for woodworking benchscrew

  • Hello, I'm a woodworker making a vise for a workbench. A metalworking friend...
  • « previous thread

  • safe disposal of chemicals

  • Hi. I just bought a house in the woods. The garage is a separate building, and I...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.