monarch EE lathe

- R
- Rick
  
  Contact options for registered users
posted
19 years ago

Thu, Jul 15, 2004 5:29 PM

Before I waste any time on this, did anyone go see the Monarch EE lathe in Kent? What was wrong with it?

Thanks,

Rick

Loading thread data ...

- R
- Rex the Wrench
  
  Contact options for registered users
Vote on answer
posted
19 years ago

Fri, Jul 16, 2004 5:22 AM

- R
- Rick
  
  Contact options for registered users
Vote on answer
posted
19 years ago

Fri, Jul 16, 2004 6:10 PM

Kent, WA. If it is any good, I guess it is sold by now. They were asking about $3000. Usually there are four or five guys on here that go see just about every lathe in this state. :-) I thought they might chime in.

XML Sitemap
Terms of Service
Privacy Policy
Contact

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.