PICTURES of the Milwaukee Bench Grinder

Ignoramus21294 · 2009-10-20T18:27:16+00:00

Shows some pictures of repair of the grinder and the assembled grinder. for my vibration issue, I think that I have a good grip on it. 1) Vibration of the mounted abrasive wheel was fixed by dressing it2) Vibration of the wire brush was UNFIXABLE and was fixed by removingthe wire brush.Now it runs quietly and does not vibrate too much. It does not go onspinning for minutes after being turned off, due to friction inbearing seals and the starting circuit, but that could be actuallybetter than going on for minutes. I am not putting it on ebay yet, because I am still consideringswapping my old 1/2 HP Baldor for this 3/4 HP grinder. The end resultof that would be having more grinder and some extra cash. If I do that I have a 60 grit wheel on it now, and no second wheel(due to removal of the wirebrush, which I do not need on a grinder). Would you think that a green wheel would be a better alternative thana regular wheel?i

Oct 20, 2009 20 Replies

Rate this thread:

Ignoramus17693 16 years ago

I wonder how the discussion turned from "PICTURES of the Milwaukee Bench Grinder" to discussion of tasteless offshore drilling senators. Seems that it took a few turns to get here from there.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required

PICTURES of the Milwaukee Bench Grinder

Related discussions

I need a better bench grinder

Vise for pipe threading

The 1 Inch Belt Grinder Solution

Join the Discussion

Didn't find your answer?