1. Home
  2. ⏣ General Metalworking
  3. Small glory hole

Small glory hole

Kt,

I gave the small glory hole a coating of Zircon before I left so hopefully dry and ready to go tomorrow. The heat lamp seems to have failed, maybe the bulb, or I would have left it to the dry the zircon. I expect we can pop a torch in the burner port hole to dry and heat up the bits before the main burner is used.

Cheers,

Dave

Reply to
David Billington
Loading thread data ...

That opens up more questions than it answer. So, what are you building, again?

Christopher A. Young Learn more about Jesus

formatting link
.

I gave the small glory hole a coating of Zircon before I left so hopefully dry and ready to go tomorrow. The heat lamp seems to have failed, maybe the bulb, or I would have left it to the dry the zircon. I expect we can pop a torch in the burner port hole to dry and heat up the bits before the main burner is used.

Cheers,

Dave

Reply to
Stormin Mormon

Obviously sent in error, but I didn't know you were a glass blower.

Paul K. Dickman

Reply to
Paul K. Dickman

Definitely some kind of blower, if he uses a glory hole.

i
Reply to
Ignoramus21956

ROFLMAO!!!

The methodology of the left has always been:

  1. Lie
  2. Repeat the lie as many times as possible
  3. Have as many people repeat the lie as often as possible
  4. Eventually, the uninformed believe the lie
  5. The lie will then be made into some form oflaw
  6. Then everyone must conform to the lie
Reply to
Gunner

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.