Hi all just a quick qustion, do I when turning eccentic (on the lathe) using the four jaw, have the offset the same as needed on spindle or as twice the value?
thanks Mike Cole
Hi all just a quick qustion, do I when turning eccentic (on the lathe) using the four jaw, have the offset the same as needed on spindle or as twice the value?
thanks Mike Cole
Surely, it is half the value...
Best regards, Dave Colliver.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.