Sliding and surfacing

Have been reading manuals again,bit confused ...yet again.Which oine of the above two is facing ??? The best i can fathom is the surfacing
is the same as facing ??am i on the money......thanks in advance.Happy xmas
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload

Yup bang on.
Usually surfacing or facing is usually at 1/2 the feed of the same range when facing.
John S.
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
On or around Sun, 21 Dec 2008 15:57:07 -0800 (PST), John S

I've a vague idea the Student is 1/4, BICBW.
--
Austin Shackles. www.ddol-las.net my opinions are just that
Travel The Galaxy! Meet Fascinating Life Forms...
  Click to see the full signature.
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
On 22 Dec, 08:42, Austin Shackles

Yes but once they are out of their time they move up to 1/2.
John S.
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
On Mon, 22 Dec 2008 08:42:48 +0000, Austin Shackles

There's all sorts of variations on the theme: Southbends, Boxfords & small S&B's it's 0.3/1. Metric S&B1024's 0.4/1 and Imperial ones 1/2 so there's clearly no 'normal' or standard, just a general tendancy.
Richard
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload

Polytechforum.com is a website by engineers for engineers. It is not affiliated with any of manufacturers or vendors discussed here. All logos and trade names are the property of their respective owners.