When we updated from SW2004 to SW2008 recently, it did some funky stuff with our drawings that had used the Geometric Tolerance part of SW. It has added a Diameter Symbol where none was before. It does this when you've used multiple Tolerances from one screen. These are square parts, so weird that it chooes the Diameter symbol at all. For instance if it used to look like this:
- Flatness - .001
- Parallel - .001 - A
It will now look like this after conversion:
- Flatness - .001 - Theta
- Parallel - .001 - A
Anyone ever experience this and find a workaround? I must add I like the new Geometric Tolerance interface much better in 2008, but we'll have a quite a few "Theta" symbols to delete.
~pope