ISO versus ANSI

Do you have any sources for dimensioning standards; recommended drawing formats based on industry?

I design consumer products. All manufacturing is done in the US. American/British/ips is the only unit system acceptable. ISO dimensioning properties seem less clumsy in SW04.3. Any comments on mixing ISO with Inch/Pound/Second units?

Thx

Reply to
xbowman
Loading thread data ...

If you initially install and specify ISO, make sure you get a 3rd angle projection drawing template. I have seen many people get the 1st angle template and get drawings that don't make sense to Americans.

matt

"xbowman" wrote in news:I9Fmc.4304$ snipped-for-privacy@fe1.columbus.rr.com:

Reply to
matt

No good engineering or designer should be without it...........

formatting link
It has all the information you may want, but if you want to make it really interesting add this......

formatting link
Me

Reply to
News

Reply to
xbowman

Thanks for the links. WOW on the prices though.

dimensioning

Reply to
xbowman

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.