I want to draw an arc but when I use the command CreateArc2 it isn't in the right position, at least the last point isn't.
CreateArc2 Center, P1, P2, direction
the Center and P1 are ok, but P2 have other coordinate.
Some help plz.
I want to draw an arc but when I use the command CreateArc2 it isn't in the right position, at least the last point isn't.
CreateArc2 Center, P1, P2, direction
the Center and P1 are ok, but P2 have other coordinate.
Some help plz.
Dear Luis,
Well can u more explain as wot u r trying 2 do and what problem u r facing
may a sketch will help us 2 understand and give u a solution
Regards
Deepak Gupta
Luis C. Fl=F3rez G. wrote:
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.