Are 5- 3/16" holes in a tuyere in a farries 16-1/2" forge, with a 100 cfm
blower, enough?
- posted
16 years ago
- Home
- ⚡ Welding Forums
- Tuyere holes
Tuyere holes
Loading thread data ...
Further Reading
-
Tuyere holes ???
- Are 5- 3/16" holes in a tuyere in a farries 16-1/2" forge, with a 100 cfmblower,...
-
Holes in steel studs?
- I have been struggling cutting holes in steel studs (actually in the top plate)....
-
C-47, Holes in Windows?
- Hi y'all,RE: WWII C-47What in the heck are all those round "holes", "ports",...
-
Drilling holes in 1-2-3 blocks
- I just sent this off to the Yahoo mill-drill group and decided somercm folks...
-
1/16" drill bit won't fit a 1/2" chuck
- I've been culling my collection of crap. Decided to reduce the number of...
-
1/16" bms rod
- Does anyone know of a source of 1/16" bms rod? I need some but can'tfind a...
-
Drill square holes in metal?
- A 3-tooth gearwheel on the drill chuck, engaging the inside of a stationary...
-
Making 4-11/16" Holes in Al Panel
- Sorry, I accidentally sent the message before I was done blathering!I need to...
-
Amperage to stick weld 3/16" square tube to 3/16" plate
- I need to weld square tubing with 3/16" walls, to 3/16" plate (tubingparallel to...
-
Drilling holes in a 1-2-3 block
- Another poster reported success in drilling the unthreaded holes in a cheap...
-
1" x 16 tpi nuts?
- Talking about unusual threads, does anyone have two 1" x 16 tpi half nuts (or ...
-
3/16 x 1/2 aluminum bar
- I would really, really like to get my hands on some 3/16" x 1/2" aluminum bar...
-
Smithy 3 in 1
- looked at a Smithy 3 in 1 today for $500. Not too bad shape, not much for...
-
propane torch conversion to natural gas?
- Brazing, not welding, but .. I have some propane/air torches I want to convert...
- « previous thread
-
MIG wire speed control problems
- Hi all: I am trying to repair the wire speed control on a Century welder Model...
- next thread »